A Starlink router wall mount will help you set up your Starlink router in a tidy manner.
The conventional way is to lay the router on a platform like a shelf.
But what about a case where you have nowhere to place it?
That’s where a wall mount comes in handy. Our guide takes you through its features and how to install it.
What is Starlink Router Wall Mount?
It is a mount option for installing the Starlink Gen 2 router. You’ll come across many types in the market, but our recommended type is the ISEKIE router wall mount kit.
It’s cheaply available on Amazon, and we suggest you go specifically for its # DF1177 model.
So, what makes it the best fit?
- It is a versatile mounting platform; you can mount it on the wall or as a router stand.
- It is a long-lasting mounting solution comprising molded Acrylonitrile Butadiene Styrene (ABS plastic).
- Thirdly, this is a very affordable router, retailing at around $20 on Amazon (At the time of this guide’s writing).
- Also, it has a small form factor, meaning it occupies minimal space on your wall.
- In addition, it’s compatible with all wall types, whether wood or drywall. Also, securing it is straightforward since it comes with screw holes at its rear side.
- Finally, installing the router and dismounting it is easy.
How to install Starlink Router Wall Mount?
You won’t sweat setting up this wall mount as it requires so little experience. Find out the installation procedure from this section.
Assemble the Necessary Components
A Spirit level.
You will require the following tools:
- A spirit level.
- A screwdriver (You need one with a Philips head).
- An Awl.
Identify a Mounting Location
Drilling.
- Your ideal mounting location should be clear, without studs or plumbing work underneath. Also, you should ensure no electrical cables.
- Another critical thing to consider is where the Starlink cable from the dish enters the house. Your mounting spot should be as close to the cable’s entry point as possible.
- Once you have an ideal position, lay a spirit level underneath and locate the most even mount installation position. Now mark the points where you will drill the screws.
Drive-in Drywall Anchors
Plastic Dowells.
- Remove the mount from the wall to make holes in the points you marked earlier. As we highlighted earlier, the tool you’ll use in this step will depend on the kind of wall.
- The rule of thumb is that your holes must accommodate the drywall anchors perfectly. So they should be just slightly larger than the anchors.
- So, after you drill the holes, place the anchors into them and ensure they are flush to the wall for a clean job.
Install the Mount
- Now, lay the Starlink wall mount in position and ensure its holes match the ones you made on the drywall.
- The mount comes with a pair of screws which you will use to install the mount on the wall. Gently drive in the screws while holding the mount in position with the other hand. Before tightening them, place a spirit level below to ensure the Starlink mount still occupies the right position.
Install the Starlink Router
- Run your Starlink cable below the mount’s underside hole to ensure they are tidy on the wall.
- Earlier, we recommended you choose a position close to where the cable from the dish above enters the house. The aim was to ensure perfect alignment with the mount.
- Now place your Starlink router on the mount, and you can clip it to ensure it’s excellently grounded via the clips on the mount sides.
- You can tuck the cables underneath the mount if they’re lying all over the place for a tidy look.
Conclusion
Now you know how to ensure your router stands out and is in an optimal position for efficient signal distribution.
Get your Starlink router adapter and have a seamless, clean setup in your home.